You may also be interested in the following product(s)
E-Type 32 tall 1/2" (L)
$359.95
|
E-Type 40 Tall 1/2" (L)
$429.95
|
IPSC 2/3 scale 1/2" thick (L)
$189.95
|
DOD MIL Spec for 1/2" thick Only Base
30 inch long....18inches wide.... 32 inches tall... 23.5 pounds Target sold separately.
Meets Department Of Defense Military Specifications for Steel targets.
30 inch long....18inches wide.... 32 inches tall... 23.5 pounds
*** To be used only with 1/2 inch thick targets ***
Designed to hold ONE Large SALUTE target. The targets are held stationary with a 30 degree forward tilt to deflect bullet fragments downward and into the ground beneath the target.
Easily brakes down to fit into the trunk of a car. This target stand is made in a modular system so that you can replace the Upright Angle Iron part if it gets shot. The replacement part can be found on our Target Accessory Page. https://www.saluteproducts.com/index.php?cPath=53
This Target Stand is designed to get full use of your target by allowing you reverse it in the stand so it can be shot on both sides.
You get an audible ring each time the target is hit. This target base is very good for multiple and simultaneous bullet impacts because it does not change its angle on impact. Many law enforcement and military training instructors request this target base system for this reason.
___________________________________________________
For use with all Large Targets
.jpg)
| Manufacturer | Salute Products Inc. |
|---|---|
| SKU | 120DOD |
| Weight (lbs) | 23.7500 |
| Target Size | No |
| Base Compatibility | No |
| Base Size | Large |








